Dialing In And Invoking Rcm - Compaq AlphaServer 1200 User Manual

6.2.2 Dialing In and Invoking RCM

To dial in to the RCM modem port, dial the modem, enter the modem password at
the # prompt, and type the escape sequence. Use the hangup command to terminate
the session.
A sample dial-in dialog would look similar to the following:
Example 6–1 Sample Remote Dial-In Dialog
ATQ0V1E1S0=0
OK
ATDT30167
CONNECT 9600
#
RCM V2.0
RCM>
Dialing In and Invoking RCM
1. Dial the number for the modem connected to the modem port. See
Example 6–1 for an example.
The RCM prompts for a password with a "#" character. See
2. Enter the password that you set with the setpass command.
You have three tries to correctly enter the password. After three incorrect tries,
the connection is terminated, and the modem is not answered again for 5
minutes. When you successfully enter the password, the RCM banner is
´
displayed. See . You are connected to the system COM1 port, and you have
control of the SRM console.
NOTE: At this point no one at the local terminal can perform any tasks except
for typing the RCM escape sequence. The local terminal displays any SRM
console output entered remotely.
3. Type the RCM escape sequence (not echoed).
^]^]rcm
RCM>
NOTE: From RCM command mode, you can change the escape sequence for
invoking RCM, if desired. Use the setesc command to change the sequence. Be
sure to record the new escape sequence.
²
³
´
Managing the System Remotely 6-5
²
in
³
.