Compaq AlphaServer 1200 User Manual page 206

poweron
The poweron command requests the RCM to power on the system. The poweron
command is equivalent to pressing the On/Off button on the control panel to the on
position. For the system power to come on, the following conditions must be met:
•
AC power must be present at the power supply inputs.
•
The On/Off button must be in the on position.
•
All system interlocks must be set correctly.
The RCM exits command mode and reconnects the user's terminal to the system
console port.
RCM>poweron
Focus returned to COM port
NOTE: If the system is powered off with the On/Off button, the system will not
power up. The RCM will not override the "off" state of the On/Off button. If the
system is already powered on, the poweron command has no effect.
quit
The quit command exits the user from command mode and reconnects the serial
terminal to the system console port. The following message is displayed:
Focus returned to COM port
The next display depends on what the system was doing when the RCM was
invoked. For example, if the RCM was invoked from the SRM console prompt, the
console prompt will be displayed when you enter a carriage return. Or, if the RCM
was invoked from the operating system prompt, the operating system prompt will be
displayed when you enter a carriage return.
reset
The reset command requests the RCM to reset the hardware. The reset command is
equivalent to pressing the Reset button on the control panel.
RCM>reset
Focus returned to COM port
6-12 User's Guide