Rear Panel - Pentax EPK-i7010 Instructions For Use Manual

Rear Panel

RJ45
This connector is exclusively for
RJ45 communication.
DVI
This connector is for outputting
video signals (DVI signals [digital]
and VGA signals [analog]) to send
to a monitor or image processor.
KEYBOARD
2
This connector is for connecting a
keyboard. Connect the supplied
keyboard (OS-A83) designed
specifically for use with this
processor.
AUDIO IN
This connector is for inputting
audio signals when recording
video images to "Image
Recording Media"(P.91).
FTSW
This connector is for
connecting foot switches
(OS-A61) for operating
peripheral devices.
HD-SDI
These connectors (BNC)
are for outputting digital
video signals (HD-SDI
signals) to send to a monitor
or image processor.
VIDEO IN
This input connector (BNC) is for
P-in-P (Picture in Picture). It inputs
composite video signals to send to
a monitor when P-in-P mode is set.
WARNING
 To avoid the risk of electric shock, this equipment must only be connected to a power supply with protective earth.
 This equipment must be connected to an appropriate power supply.
Make sure to firmly connect each connector to the specified position. Failing to do so could cause certain function to be
unavailable.
7
Nomenclature, Controls, and Functions
Rating Plate
This plate shows the
processor rating
specifications, acquired
standards, etc.
Air Intake Vent
Note
Install the processor in a location
where the air intake vents will
not be blocked.
RS-232C
This connector (D-sub 9-pin
connector) is for connecting an
external output device. It is an
RS-232C compliant interface.
USB
These connectors are for connecting
"Image Recording Media"(P.91) or a
USB printer.
RGB
This connector is for outputting
video signals (RGB color signals
and synchronous signals) to send
to a monitor or image processor.
Y/C
These connectors (separated video
outputs) are for outputting separate
video signals (video signals
separated into luminance signals
and color signals) to send to a
monitor, printer, or image processor.
VIDEO OUT/
SYNC OUT
This connector (BNC) is
for outputting composite
video signals and strobe
synchronous signals to
send to a monitor or
image processor.
REMOTE
These connectors are
for outputting operation
trigger signals to
remotely operate
peripheral devices.
Air Intake Vent
Note
Install the processor in a location
where the air intake vents will
not be blocked.
Fuse Box
This fuse box contains two fuses.
Power Input Socket
Connect the AC power cord.
Potential Equalization Terminal
This terminal is used with a
potential equalization busbar to
equalize the potential of other
equipment connected to the
processor.