Pentax EPK-i7010 Instructions For Use Manual page 46

 Image rotate
Set the display orientation of the endoscopic image.
1
Press [Normal] or [Rotate].
 Twin mode
Set or cancel twin mode.
I "Twin Mode Screen" (P.24)
1
Press [Off] or [On].
• If an endoscope is not connected to the processor, the message "Connect endoscope." appears.
NOTE
5
 If [SE] or other image processing is performed in twin mode, the processing is only reflected on the image on the right
side of the screen. The image processing parameters are inherited by the normal screen when twin mode is
cancelled.
 When the Twin mode setup is made after freezing, an image processing is not reflected in the left side screen. In the
case where the USB capture is performed as is, an image-processing parametric information is added to the still
picture even if not checking [Add image processing parameter information.]of [Option (Still image)]. And the image-
processing parametric information of the left side screen displays "-". Image processing of the left side screen will
become effective after freezing release.
 90K, K10 and J10 series endoscopes do not correspond to the Twin mode of white light and OE.
 (When executed an image-processing)In case that the display is too dark to obtain a proper observation result, we
recommend you to return to a normal observation display or change one display into white light.
 Twin mode display
Set the sizes of the image on the left side of the screen and on the right side of the screen in twin mode.
1
Select [1:1], [3:2], or [2:3].
[1:1]
NOTE
The [Twin mode display] setting is stored in memory even after you turn off the processor.
41
Operating Procedure
[Normal]
[3:2]
[Rotate]
[2:3]