Pentax EPK-i7010 Instructions For Use Manual page 47

 Twin mode profile
Set the image processing for twin mode.
1
Press [>].
• The [Twin mode profile] screen appears.
• The setting value in the main screen and the other screens is
displayed for each item.
2
Select [Off] or [On] for [Profile setting].
[Off]: The [Twin mode profile] screen is not displayed in twin
mode. Image processing parameters other than
[Enhancement] are not reflected on the left side of the
screen.
[On]: The [Twin mode profile] screen is always displayed on the
left side of screen in twin mode. "TM profile" is displayed
in the upper left of the left side of the screen.
3
Press the parameter box for which you want to
change the setting.
• When a parameter box is selected, it turns blue and buttons for changing the selected parameter appear at the bottom
of the screen.
4
Change the setting with the buttons at the bottom of the screen.
• If the parameter box does not turn blue, the buttons will not function properly.
5
Press [Save].
• The changes are saved.
• If [Load] was pressed when the setting values were changed, the saved setting values are loaded.
NOTE
 If you attempt to perform a keyboard operation other than pressing the [Lamp] or [Pump] key, endoscope button
operation, or foot switch operation in the [Twin mode profile] screen, the message "Close profile menu." appears on
the monitor and the operation cannot be performed.
 When the Twin mode setup is made after freezing, an image processing is not reflected in the left side screen. In the
case where the USB capture is performed as is, an image-processing parametric information is added to the still
picture even if not checking [Add image processing parameter information.]of [Option (Still image)]. And the image-
processing parametric information of the left side screen displays "-". Image processing of the left side screen will
become effective after freezing release.
Set whether to display
the [Twin mode profile]
screen.
Load the recommended setting values.
Change the setting of the parameter.
Press the parameter box for which you want
to change the setting.
Operating Procedure
Load the saved
twin mode
setting values.
Save the changes.
5
42