Pentax EPK-i7010 Instructions For Use Manual page 88

 Installing a Lamp Cartridge
When performing the following procedure, always wear rubber gloves to prevent oil from your hands from getting on the
glass surfaces. Do not directly touch the glass surfaces of the new lamp with your fingers.
1
Hold the lamp cartridge so that the two screws on the
lamp cartridge are at the front and fully insert it into
the housing while keeping it straight. (Refer to Figure
6.4.)
2
Turn the screws of the lamp cartridge clockwise to
secure the lamp cartridge into place.
3
Close the lamp protective cover and turn the screw
on the right side of the cover clockwise.
Be sure to turn screw 1 on the lamp cartridge first to secure the
lamp cartridge in place.
 Resetting the Lamp Life Indicator
After replacing the lamp cartridge, reset the lamp life indicator on the front panel of the processor.
1
Plug the power cord into the power outlet and turn on the processor.
2
Press e on the touch panel.
• The setup screen appears.
3
6
Press the [System] tab at the top of the screen.
• The system setup screen appears.
4
Press the page [3] tab on the right side of the screen.
5
Press [>] of [Lamp data].
• The [Lamp data] screen appears.
6
Press [Reset] of [Lamp life reset].
• The [Lamp life reset] confirmation screen appears.
7
Press [Yes].
8
Press the R power switch to turn off the processor and then press R again to turn the
processor back on. Confirm that the lamp life indicator illuminates green.
83
Maintenance
2 1
Figure 6.4