Pentax EPK-i7010 Instructions For Use Manual page 45

When [Scope enhancement] on the [Customize] tab is set to [Disable]
2
Press [Off] or one of two types × six levels.
• A higher numerical value sets a higher level for edge
enhancement / structure enhancement display.
[+1 to +6] Edge enhancement mode
[+1/a1 to +6/a6] Edge enhancement / Structure enhancement
mode : allows for enhancing the mucous membrane structure
and contour.
When connecting the 70K, 80K, 90K, K10 and J10 series
endoscope, the edge enhancement mode [+1 to +6] is effective,
and when the i series endoscope is connected, the structure
enhancement mode [a1 to a6] becomes effective.
Structure enhancement mode and [SE] cannot be processed simultaneously.
Be sure to check that the endoscopic images on the monitor are not static and that the images are displayed with the
correct orientation each time after changes have been made to [Enhancement].
 Noise reduction
Set the level for noise reduction.
1
Select [Off], [Low], [Medium], or [High].
Be sure to check that the endoscopic images on the monitor are not static and that the images are displayed with the
correct orientation each time after changes have been made to [Noise reduction].
NOTE
If [SE], [CE], or [Enhancement] is used, noise may become visible in the image on the monitor screen.
 Contrast
Select the mode for contrast processing.
1
Select [Normal], [Mode1], or [Mode2].
Be sure to check that the endoscopic images on the monitor are not static and that the images are displayed with the
correct orientation each time after changes have been made to [Contrast].
NOTE
The [Enhancement], [Noise reduction], and [Contrast] settings are stored in memory even after you turn off the
processor.
 Digital zoom
Set the magnification ratio of endoscopic images.
1
Select [Off], [x1.2], [x1.5], or [x2.0].
NOTE
As the optical or electronic expanded observation display has a narrow view, please secure a view enough when
performing an operation.
Operating Procedure
5
40