Pentax EPK-i7010 Instructions For Use Manual page 20

Connecting USB flash memory
Connect the USB flash memory(TS32GJF600) to a USB port on the front or rear of the processor.
Connecting an external hard disk drive
Connect the external hard disk drive (WDBBGB0030HBK) to a USB port on the front or rear of the processor.
NOTE
 Some Image Recording Media may not be recognized by the processor.
 It is possible that the correct data recording could be compromised because of using the USB3.0 compatible cable.
 Connecting Other Peripheral Devices
For details, refer to the corresponding IFU.
3
Keyboard OS-A83
Microphone
Foot Switch OS-A61
Connecting a keyboard
Connect the PENTAX Medical keyboard (OS-A83) to the KEYBOARD connector.
Connecting foot switches
Connect the PENTAX foot switches (OS-A61) to the FTSW connector.
Connecting a peripheral devices supporting remote (trigger) input
When you want to use a peripheral device that includes support for remote (trigger) input, use a control cable (OS-A58) to
connect the REMOTE connector to the remote connector on the peripheral device. For details on a peripheral device, refer to
the IFU for the peripheral device.
Connecting an external strobe device
Connect the VIDEO OUT/SYNC OUT connector to the signal connector on an external strobe device recommended by
PENTAX Medical. For details on connecting a compatible device, refer to the IFU for the compatible device.
Connecting a microphone
If you want to record video images with audio, connect a microphone to the AUDIO IN connector. Use a microphone (with the
following specifications) recommended by PENTAX Medical.
Type: Stereo mini-plug (three pins)
Support for plug-in-power
Microphone characteristics: Sensitivity of -40 to -50 dB(0dB = 1V/1Pa, 1kHz)
15
Preparation
LAN Cable
RS-232C Cable
BNC Cable OS-A17
Control Cable OS-A58
External network
equipment
Endonet system
External Strobe
Equipment
Peripheral devices
supporting remote
(trigger) input