Pentax EPK-i7010 Instructions For Use Manual page 72

 Freeze release
Set the method for freeze release.
[Off] The frozen image is maintained even after the still image is saved. Release the frozen image manually.
[On] Freeze is released automatically when the still image is saved.
1
Press [Off] or [On].
 Manual brightness level
Set the brightness adjustment level by endoscope type for when the exposure control method is set to [MANUAL].
[Normal] Use this mode for the observation with normal brightness adjustment level.
[Boost] Use this mode for the observation with higher brightness adjustment level. This mode is intended for the use with
an otolaryngology endoscope with small diameter.
1
Press [Normal] or [Boost].
 Use [Normal] mode at first for any observation.
 If the [Boost] mode is used when a gastrointestinal endoscope with large diameter is connected, do not perform
observation for a long time with brightness level +4 or higher. Failure to do so could result in a burn injury.
NOTE
If an electronic endoscope is connected, [Boost] cannot be selected.
 Lamp data
5
Confirm the lamp usage time, configure the lamp ignition method setting, etc.
1
Press [>].
• The [Lamp data] screen appears.
2
Configure the [Lamp ignition] setting or reset the
lamp life counter with [Lamp life reset].
 Lamp ignition
Set the lamp ignition method.
[Manual] The lamp can be turned on manually from the touch panel
or keyboard.
[Power on] The lamp turns on automatically when the processor is
turned on.
1
Press [Manual] or [Power on].
 Lamp life reset
Reset the lamp life counter.
1
Press [Reset].
• The confirmation screen appears.
2
Press [Yes].
• The lamp life counter is reset to "00:00:00."
• Pressing [No] returns to the previous screen without resetting the lamp life counter.
67
Operating Procedure
The lamp life counter The number of
is displayed. times the lamp life
counter has been
reset is displayed.
Press any of the buttons to configure the
setting.