Table of Contents
Advertisement
This is a special function which allows Futaba motor controller (MC) data changes to be set
by the T7XC transmitter (MC960CR, MC950CR, MC851C, MC602C, MC402CR, etc.).
However, some data changes require a PC and Link software.
This function is used by connecting ESC directly to the transmitter.
Use the various optional servo extension cords according to the distance between the trans-
mitter and ESC.
Cover
-Also connect the battery at the ESC side.
Home screen
MC (ESC) Link
Menu screen
Accessory menu screen
MC (ESC) Link
Communication port.
Battery
Connecting ESC receiver
connector to the transmitter
Communication port.
MC (ESC) Link
Setup item (after it reads)
Read
Write
Reset
Data list
139
Advertisement
Table of Contents
