Brake Mixing - FUTABA 7XC Instruction Manual

This function is used when the front and rear brakes must be adjusted independently such
as a 1/5 scale GP car. This mixing uses the 2nd channel for the rear brakes and the auxiliary
channel for the front brakes, or controls the front brakes with the auxiliary channel servos,
or controls the 2nd channel by independent throttle and controls the rear and front brakes
with the auxiliary channel. In addition, mixing which varies the auxiliary channels brake
rate in proportion to steering operation is also possible.
Operation
-When braking, mixing is applied from brake 1 to brake 2 and brake 3.
-Brake 2 and brake 3 amount, brake 1,2,3 delay, and Brake 2 and brake 3 EXP and ABS
can be set.
-Steering mixing which varies front brakes brake 2,3 (auxiliary channels) matched to
the steering operation can be set. Front brake 2,3 (auxiliary channels) can be individu-
ally weakened according to the steering left or right operation amount.
When Throttle mode (Trigger) ratio was set to 100:0
When " Throttle mode (Trigger) Ratio " (page 60) was set to 100:0, brake operation stops.
When using brake mixing, set the " Throttle mode (Trigger) Ratio " to 70:30 or 50:50.
Auxiliary channels A.B.S
Brake mixing can also use the " A.B.S " function (page 88) for 2nd and 3rd brakes. Except
for throttle point and steering mixing, it can be set exclusively for 2nd and 3rd brakes
side. Even if the " A.B.S " function on the1st brake (2nd channel) side is OFF, you can
also use the A. B. S function on the 2nd and 3rd brakes side alone. You can set the ON /
OFF of the " A.B.S " (brake 2, 3) function with the " Switch select " function (page 67).
104

Brake Mixing

Front Brake
Brake 2/3
Rear Brake
Brake 1
or Brake 2/3
Brake Mixing