FUTABA 7XC Instruction Manual page 100

1
(Preset position setup)
Tap the value button of the [Preset]. Value
input buttons appear on the screen. Use the
[+] and [-] buttons to set the preset position
of the throttle servo.
2
When finished, return to the Linkage menu screen by pressing the HOME button.
Dial / Trim Setting
The engine cut preset position can be adjusted with digital trim DT1 to DT6 or digital
dial DL1, with the " Trim / Dial select " function (page 64).
The throttle servo operating position (preset position) set by this setting is unrelated to
the setting of other functions. Maximum to minimum servo travel can be set. However,
the reverse function setting is enabled.
Caution
Always operate carefully before using this function.
When engine cut switch is in the ON state, the servo (motor controller) is locked in the preset position and does
not operate even if the throttle stick is operated. If the servo was operated at the wrong setting, you may lose
control of the car (boat).
100
Engine Cut
*Shows the ON/OFF state
Adjust button
Adjust with the [+] and [-] but-
tons.
- Return to the initial value by
tapping the [reset] buttons.
Preset position
0~100
Initial value: 0