FUTABA 7XC Instruction Manual page 134

Connection diagram of wired system
Cover
Connection diagram of wireless system
- Reference
When using "S.BUS / S.BUS2" servo with
steering mixing (page 101) with a twin ser-
vo specifi cation car such as 1/5 GP car, 1st
channel and 2nd channel are set to steer-
ing, both servos can be wirelessly set. Change throttle to 3rd
channel or 4th channel in the channel setting function (page 73).
Home screen
Using the S.BUS servo function
(Preparation)
- Connect the S.BUS or S.BUS2 servo in accordance with the connection diagram.
- Connect the battery to a non-high voltage (HV) support S.BUS/S.BUS2 servo.
- Always use wired method to change normal mode and SR mode. Cannot change the
mode with the wireless setting.
1
The transmitter's power switch turns on the PWR side and outputs radio waves. Wireless
setting are not be used on the DISP side. Turn on the battery switch of the receiver and con-
fi rm that the servos can operate. The S.BUS servo screen will be displayed as above.
134
Accessory menu screen
Menu screen
S.BUS Servo
Communication port.
(HV servo)
Connecting S.BUS/S.BUS2 servo connec-
tor to the transmitter Communication port.
Wireless 2 (Rx Ch2)
Wireless 1 (Rx Ch1)
Wireless setting of servo con-
nected to 3rd channel and
4th channel is not possible.
S.Bus servo