Mc (Esc) Link - FUTABA T10PX Full Manual

This is a special function that allows the Futaba motor controller (ESC) data changes
to be set by the T10PX transmitter. (MC960CR, MC950CR, MC851C, MC602C, MC-
402CR, etc.). However, some data changes require a PC and Link software.
This function is used by connecting ESC directly to the transmitter.
transmitter and ESC.
-In the wireless setting, reading / writing / reset / initialization may take a long time or
may fail depending on the surrounding radio wave environment. If it fails, try again.
-Also, connect the battery at the ESC side.
Menu screen
Home screen
ACCESSORY MENU

MC (ESC) Link

Communication port.
Cover
Accessory menu screen
Setup item (after it reads)
Read
Write
Reset
Data list
188
Connecting the ESC receiver
connector to the transmitter
Communication port.
Battery
MC (ESC) Link
For ESC in the past, please
choose Other.
*MC970CR is available only in the
Japanese market. (As of Dec. 2021)
Return to table of contents