This is a special function which allows Futaba motor controller (MC) data changes to be set
by the T7PX transmitter (MC960CR, MC950CR, MC851C, MC602C, MC402CR, etc.).
However, some data changes require a PC and Link software.
This function is used by connecting ESC directly to the transmitter.
Use the various optional servo extension cords according to the distance between the trans-
mitter and ESC.
-Also connect the battery at the ESC side.
Home screen
140
1M23N32602_7PX_E.indb
140
MC Link (ESC Link)
Communication port.
Cover
Battery
Menu screen
Accessory menu screen
Setup item (after it reads)
Read
Write
Reset
Data list
MC Link (ESC Link)
Connecting ESC receiver
connector to the transmitter
Communication port.
Timer
2017/08/02
14:17:36