FUTABA 7XC Instruction Manual page 61

Neutral brake "Rate"
Neutral Brake function adjustment
(Preparation)
- Use the switch select function to the "Switch select" (page 67).
When the switch is not set "A switch is not assigned" is dis-
played. Tap [Switch select] to display the switch selection screen
and set the switch.
1
(Neutral brake rate)
Tap the value button of the [Rate]. Value input
buttons appear on the screen and use the
[+] and [-] buttons to adjust the neutral brake
rate amount.
2
When fi nished, return to the Linkage menu screen by pressing the HOME button.
Reference
The ESC neutral brake function and T7XC neutral brake function can be used simulta-
neously. However, when setting is dif昀椀 cult to understand, we recommend that only one
neutral brake function be used.
Dial / Trim Setting
When the neutral brake function is
cally assigned to the throttle trim (DT1 to DT6 or DL1).
Effect of set value of other functions on neutral brake
Throttle side EPA function, or ATL function setting also affects neutral brake side op-
eration. The " Idle-up " (page 70) or " Engine Cut " (page 99) function has priority.
Neutral brake ON/OFF is indi-
cated on the home screen for a
few seconds.
When the neutral brake is ON,
the display of the throttle trim on
the home screen becomes the
neutral brake.
I t i s d i s p l ay e d i n t h e h o m e
screen, when the neutral brake is
ON.
ON
"
Throttle mode (Trigger)
If the power switch is
turned on while the neu-
tral brake switch is on,
an audible alarm will be
heard. Immediately set
the neutral brake switch
to OFF.
, the neutral brake rate adjustment is automati-
"
Adjust button
Adjust with the [+] and [-] but-
tons.
- Return to the initial value by
tapping the [reset] buttons.
Neutral Brake
0~100
Initial value: 0
Warning display
61