FUTABA 7XC Instruction Manual page 109

Gyro mixing adjustment
(Preparation)
- Refer to the gyro instruction manual and connect the gyro to the receiver. When using remote
gain, connect gyro sensitivity adjustment to the auxiliary channels of the receiver.
- When using gyro mixing by switching between the NORM (normal) and AVCS modes, use
the "Switch select" function (page 67) to set the switch to be used.
1
(Function ON/OFF)
Tap "Mixing" (ON) or (OFF) to select ON /
OFF.
"OFF" :Mixing function OFF
"ON" :Mixing function ON
2
(Channel setup)
The channel list screen used for the gain steering channel is displayed. Tap the auxiliary
channel that connected the gain steering channel.
- When all channels are in use, a screen saying "No assignable channel" is displayed, please turn off other mixing
and make an unused channel. You can check the mixing used on the channel setting screen (page 73).
For S-FHSS (analog)
system, channels 5, 6
and 7 are displayed.
Gyro Mixing
Setting
- Tap (ON) / (OFF).
If there is no assignable
channel, tap [Close]. Turn
off other mixing and make
assignable channels.
109