Initial Set-Up; Preparations (Transmitter); Rf Output & Rx Type Check - FUTABA 7XC Instruction Manual

(Display when power switch turned on)
When the power switch is turned on, the currently selected model number is displayed.
Check if this number is the model number you want to set-up. To change the model number,
use the " Model Select " function. (page 169)
The model number is displayed
Before setting up each function of the transmitter, check and set the following items.
RF Output & Rx Type Check
Check if the receiver system is set to the type of receiver used.
*When the " PWR " side power switch is set to ON and radio waves
are output normally, " T-FHSS SR " , " T-FHSS " , " S-FHSS " , or " FASST "
is displayed. If not displayed, there is probably an abnormality or
trouble so contact a Futaba Service Center.
When a screen is displayed at the " DSP " side, " Display " is displayed.
*Since the R334SBS receiver supplied with the T7XC set uses the T-
FHSS SR (Super response) or telemetry function T-FHSS system,
T7XC receiver setup must be set to T-FHSS SR or T-FHSS.
The R2104GF and other S-FHSS and FASST system receivers, as
well as the R304SB T-FHSS system receiver can be used with the
T7XC transmitter. However, only R614FS/FS/FF-E and R604FS/FS-E
" C2 " type receivers can be used with the FASST system.
The R603FS/FF " C1 " type cannot be used.
34

Initial Set-Up

Preparations (Transmitter)

Turn on the transmitter power.
Receiver system check
(HOME screen)
Voltage check
Receiver system check
Servo response mode, SR mode check
The figure is processed for ex-
planation of the screen. In fact,
response (digital / normal) and
SR mode are not displayed at the
same time.
"T-FHSS SR" is displayed
For "T-FHSS SR" system