Cps Mixing - FUTABA 7XC Instruction Manual

This function controls the Futaba CPS-1 channel power switch. Normally, when using the
CPS-1 unit to light the vehicle dress-up and other illumination (LED) the CPS-1 unit with
LED connected is connected to a vacant switch channel and the LEDs are turned on and off
by switch while the vehicle is running. However, when the CPS mixing function is used, the
LED can be turned on and off and 昀氀 ashed in step with steering and throttle operation, as
well as being turned on and off by switch. The 昀氀 ashing speed (cycle) can also be set. For in-
stance, the LED can be 昀氀 ashed as a brake light by throttle brake side operation. Three lines
of CPS mixing can be used.
The CPS-1 unit does not operate in SR mode. When using with the T-FHSS SR system,
connect it to the channel of the normal mode.
Home screen
Dual ESC mixing adjustment
(Preparation)
- CPS-1 unit connects to the receivers auxiliary channel.
- When the LEDs are turned on and off by switch, use the func-
tion "Switch select" function (page 67) to set the switch to be
used.
- From the CPS Mixing screen, tap [CPS Mixing 1] , [CPS Mix-
ing 2] or [CPS Mixing 3] to display the setting screen.
1
(Function ON/OFF)
Tap "Mixing" (ON) or (OFF) to select ON / OFF.
"OFF" :Mixing function OFF
"ON" :Mixing function ON
116

CPS Mixing (1, 2, 3 )

Menu screen
Menu-1
CPS function ON/OFF
i s i n d i c a t e d o n t h e
home screen for a few
seconds.
CPS Mixing (1, 2, 3 )
Mixing menu
Menu-2
The mixing function is assigned to auxiliary
channels used by other mixing cannot be used.
When the number of channels is insuf昀椀 cient,
cancel the other mixing.
CPS mixing
Setting
- Tap (ON) / (OFF).