Engine Cut; Engine Cut Off By Switch - FUTABA 7XC Instruction Manual

When the switch is pressed, the throttle servo will move to the preset position without re-
gard to the throttle stick position. This is convenient when used to cut the engine of boats,
etc (The " Switch select " function. See page 67).
Home screen
When Throttle mode (Trigger) ratio was set to 100:0
When " Throttle mode (Trigger) Ratio " (page 60) is set to 100:0, the brake side function
will not operate. The preset position set here is the linkage reference. Set the linkage so
that the carburetor is fully closed in the preset adjustment range and the engine stops.
Full throttle position is set by " Forward " of the e nd point function. Adjust the idling po-
sition with throttle trim.
Engine Cut function adjustment
(Preparation)
- Use the switch select function to the "Switch
select" (page 67).
When the switch is not set "A switch is not
assigned" is displayed. Tap [Switch select] to
display the switch selection screen and set the
switch.

Engine cut

Menu screen
Engine cut ON/OFF is indicated
on the home screen for a few
seconds.
It is displayed in the home screen,
when the engine cut is ON.
Engine cut
Racing menu screen
If the power switch is
t u r ned on wh ile t he
engine cut switch is on,
an audible alarm will be
heard. Immediately set
the engine cut switch to
OFF.
Engine cut
Warning display
99