Table of Contents
Advertisement
LINK PROCEDURE (T8J transmitter/R2008SB):
Each transmitter has an individually assigned, unique ID code. In order to start operation, the receiver must
be linked with the ID code of the transmitter with which it is being paired. Once the link is made, the ID
code is stored in the receiver and no further linking is necessary unless the receiver is to be used with another
transmitter. When you purchase additional R2008SB receivers, this procedure is necessary; otherwise the
receiver will not work.
1. Bring the transmitter and the receiver close to each other, within 20 inches (half meter).
2. Turn on the transmitter.
3. Turn on the receiver.
4. Press and hold the Link switch more than two (2) seconds. When the link is complete, the LED in the
receiver changes to solid green. When the ID cannot be read due to the surrounding environment, try
reading it with the transmitter and receiver touched.
• If there are many S-FHSS/FHSS systems turned on in close proximity, your receiver might not link to your
transmitter. In this case, even if the receiver's LED stays solid green, unfortunately the receiver might have
established a link to one of other transmitters. This is very dangerous if you do not notice this situation. In
order to avoid the problem, we strongly recommend you to doublecheck whether your receiver is really
under control by your transmitter by giving the stick input and then checking the servo response.
WARNING
After the linking is done, please cycle receiver power and check if the receiver to be linked is really
under the control by the transmitter to be linked.
Do not perform the linking procedure with motor's main wire connected or with the engine operating as
it may result in serious injury.
Please refer the table below for LED status vs
receiver's condition.
LED Indication
Green
Red
Off
Solid
No signal reception
Solid
Off
Receiving signals
Blink
Off
Receiving signals but ID is unmatched
Alternate blink
Unrecoverable error (Memory, etc.)
21
Status
Advertisement
Table of Contents
