FUTABA 7XC Instruction Manual page 160

Alarm and Vibrator function setup
1
(Limit adjustment)
Tap the "
the screen.
Use the [+] or [-] button to adjust the limit voltage.
2
(Alarm and vibrator function setup)
Tap the "
[Voice].
"Inhibit":No audible alarm/ "Buzzer":Audible alarm/ "Voice":Voice alarm
Tap the "
[Type 2], or [Type 3].
"Inhibit" :No active vibration
"Type 1" :Continuous vibration
"Type 2" :Intermittent vibration for a long time
"Type 3" :Intermittent vibration for a short time
3
(Speech function setup)
Tap the "Voice" (ON) or (OFF) to select ON / OFF.
"OFF" :No voice guide
"ON" :Information loaded by voice
4
When finished, return to the Telemetry screen by pressing the HOME button.
How to set the reference position
It takes a while for GPS to be measured after turning on the power. Please wait until the LED of
the GPS sensor turns on green without moving the car body. If the distance display does not
stabilize even after the green LED lights up, or if you set a new reference value for the place
where the car body moved, reset the reference position.
1
(reset operation)
Since either the distance / speed screen can be used, tap [Reference
position setting]. The distance is reset. After that, the distance from
the point where resetting is done is displayed until tapping [Reference
position setting] again.
160
" [ Limit] or " " [ Limit]. Value input buttons appear on
" / " " [Alarm] type and select [Inhibit], [Buzzer]or
" [Vibrator] type and select [Inhibit], [Type 1],
" / "
Telemetry
Adjustment buttons
- Adjust with the [+] and [-] but-
tons.
- Return to the initial value by
tapping the [reset] buttons.
Setting
- Tap alarm type.
Inhibit/ Buzzer/ Voice
Setting
- Tap Vibrator type.
Inhibit/ Type 1/ Type 2/ Type 3
Setting
- Tap (ON) / (OFF).
*The voice guide loading inter-
val is set by sensor menu.