Receiver Terminology; Receiver Installation - FUTABA 7XC Instruction Manual

Receiver Terminology

R334SBS
Antenna
R334SBS-E
The receiver power supply can be connected to the S.BUS2 connector or each of CH1-4.

Receiver Installation

Install the receiver on the car as follows:
NOTE: The operating range may reduced, depending on where the receiver and the antenna are mounted.
NOTE: Put the antenna in the antenna tube to protect it. Do not let the tip go outside.
NOTE: It is a receiver of diversity type with both external and internal antennas. Do not place wiring or other objects on the plate. The
receiving range may be affected.
Antenna
WARNING
Install the antenna in the higher place as shown in the figure.
Do not cut or bundle the receiver antenna wire.
Do not bend the coaxial cable. It causes damage.
Do not pull the receiver antenna or coaxial cable by force.
Keep the antenna as far away from the motor, ESC and other noise sources as you possibly can.
Wrap the receiver with something soft, such as foam rubber, to avoid vibration. If there is a chance
of getting wet, put the receiver in a waterproof bag or balloon.
28
Coaxial cable
Link switch/LED
Antenna
Cap
Antenna tube
R334SBS-E
Connectors
Link switch/LED
S.BUS2 :Power /S.BUS2 connector
Connectors
4 :CH4 servo(CH4)
3 :CH3 servo(CH3)
2 :Throttle servo(CH2)
1 :Steering servo(CH1)
S.BUS2 :Power /S.BUS2 connector
4 :CH4 servo(CH4)
3 :CH3 servo(CH3)
2 :Throttle servo(CH2)
1 :Steering servo(CH1)
Antenna tube
Antenna
Coaxial cable
R334SBS