[dw̲efipullbatterytab, 1, en̲US]
Figure 3-4
The DIP switch is located on the PCBA as shown in Figure 3-5. To change default DIP switch settings, use
²
the recommended tools (Table 3-1) and refer to the configuration label available on the inner side of the
device front cover. This label is MLFB-specific. For the detailed DIP switch settings across MLFBs, refer to
5.4.1 DIP Switch Overview section.
[dw̲efiDIPswitch̲jumper, 1, en̲US]
Figure 3-5
(1)
DIP Switch (S3)
(2)
DIP Switch (S4)
(3)
Jumper (X12)
The jumper is only present in device variants with flag (MLFB: 6MD2311-2BB10-0AA5 and 6MD2311-1DC10-0AB6). It is not appli-
13
cable in other device variants.
SICAM, Earth Fault Indicator, Manual
E50417-H8940-C600-A3, Edition 12.2022
SICAM EFI Battery Isolation Tab Removal
DIP Switch and Jumper Location on the PCBA
13
Installation and Commissioning
3.2 Device Installation and Commissioning
29