Precor Precision 400 Series Service Manual page 210

16. Switch the power "OFF".
17. Reconnect the lift yoke to the crossramp. The yoke should have been calibrated with
the yoke facing rearward, if not, repeat the yoke calibration. Lift the ramp and insert
the yoke into the back lift cover yoke slot under the ramp. Secure using the two mount-
ing bolts, washers, and nuts. Torque bolts to 240 in-lbs (20 ft-lbs, 27 Nm).
18. Switch the power "ON".
19. Start a manual Workout. Operate the INCLINE controls through the minimum to max-
imum limits while verifying normal incline operation.
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
6 Available Replacement Procedures
Lift Motor Replacement
Page 202