Precor Precision 400 Series Service Manual page 103

Number
5. Carefully set the console onto the console bracket aligning the four mounting holes.
Make sure the interface cables are neatly tucked into the console bracket and that the
cables are not pinched. Secure using the four screws and fully tighten.
1
6. Plug in the power cord and switch the power ON.
7. Start a manual workout and verify that the console powers up and operates normally.
8. Do the Operation Verification tests (see
return to service.
1
Device power cord connector or electrical cable male connector that is inserted into an
electrical receptacle "outlet" (also called the plug-in).
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
Cable
data cable
Ground cable
Touch Heart Rate cable
"Operation Verification" on
6 Available Replacement Procedures
Console Replacement
page 19) and
Page 95