6. Center the eddy current disk in the slot in the eddy current magnet (between the mag-
netic poles). Fully tighten and torque the mounting bolts to 66 in-lbs (7.5 Nm).
7. Reconnect the magnet interface cable to the eddy current magnet assembly.
8. Start a manual workout and operate the machine from min to max resistance from low
to high steps per minute. Verify normal machine resistance operation.
9. Replace all removed covers, see
10. Do the Operation Verification tests (see
return to service.
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
6 Available Replacement Procedures
Eddy Current Magnet Assy Replacement
"Covers and Panels Replacement" on
"Operation Verification" on
page 75.
page 19) and
Page 145