Äoutputting Aux-Bus Audio; Assigning The Aux Bus; Sending Audio To The Aux Bus - Roland VR-6HD Reference Manual

Outputting AUX-bus Audio
The VR-6HD has four different audio buses: the MAIN bus, AUX 1 bus, AUX 2 bus and MONITOR bus. You can assign a desired bus to each output connector
or jack.
Audio bus Explanation
MAIN bus All input audio is mixed and output (main output).
Only the input audio sent to the AUX bus is mixed and
output. This allows you to output audio that is different
than the master output.
AUX 1 bus
For example, in a live event, you might output a mix of
AUX 2 bus
all audio inputs, while separately outputting a mix of
only specific audio inputs (the AUX bus) for recording or
streaming.
MONITOR This outputs the same audio as what you hear in the
bus headphones. Use "MONITOR LEVEL" to adjust the volume.

Assigning the AUX Bus

Ó
1 .
[MENU] button "AUDIO"
press the [VALUE] knob.
The AUDIO OUTPUT ASSIGN screen appears.
2 .
Touch the screen to configure the bus to assign to each jack
or connector.
connector
AUDIO OUT 1 (XLR)–
AUDIO OUT 2 (RCA)
VIDEO OUT 1–3
PHONES OUT/MONITOR
USB OUT
STREAM/RECORD
AUDIO RECORD

Sending Audio to the AUX Bus

* Use the [AUX 1] and [AUX 2] knobs to adjust the volume of audio
output from the AUX bus.
NOTE
If AUDIO FADER/KNOB MODE is set to "CATCH", the knob
operations are ignored until the knob's position "catches up" to
the current level. (p. 138)
1 .
Press the [SETUP] button for the channel you wish to send to
the AUX bus.
The setup screen for the channel you pressed appears.
2 .
Touch <AUX 1 SEND POINT> on page 2 to set the send
amount.
Ó
select "OUTPUT ASSIGN", and
Selected bus
MAIN BUS, AUX 1 BUS,
AUX 2 BUS, MONITOR BUS
MAIN BUS, AUX 1 BUS,
AUX 2 BUS,
* For the AUX 2 bus, touch <AUX 2 SEND POINT>.
3 .
Press the lit [SETUP] button to close the setup screen.
Setting the character of the sound
You can select whether to send either the original audio or the audio
processed with effects to the AUX bus.
1 .
Press the [SETUP] button for the channel you wish to send to
the AUX bus.
The setup screen for the channel you pressed appears.
2 .
Touch <AUX 1 SEND POINT> to make that setting.
Value Explanation
DRY
Sends the source audio with no effects applied.
Sends the effect-applied audio.
PRE FADER
The send volume is constant, regardless of the volume
(INPUT LEVEL).
Sends the effect-applied audio.
POST FADER
The send volume can be changed by adjusting the
volume (INPUT LEVEL).
3 .
Press the lit [SETUP] button to close the setup screen.
MEMO
You can check the status of each channel from the [MENU] button Ó
"AUDIO" Ó SEND SETTINGS screen and adjust the send amounts at
once.
Audio Operations
55