Install A Tape Drive - Lenovo ThinkSystem ST250 V2 Maintenance Manual

Procedure
Step 1. Remove the server cover (see "Remove the server cover" on page 199).
Step 2. Disconnect the cables from the rear of the tape drive.
Step 3. Gently pull the metal tab on the side of the chassis and push the tape drive outward from the rear;
then, draw the tape drive out of the chassis.
Figure 121. Removing a tape drive
After this task is completed
1. Install one of the following:
• Another tape drive or an optical drive.
See "Install a tape drive" on page 215 or "Install an optical drive" on page 155.
• A drive filler in the vacant drive bay.
2. If you are instructed to return the component or optional device, follow all packaging instructions, and
use any packaging materials for shipping that are supplied to you.

Install a tape drive

Follow instructions in this section to install a tape drive.
About this task
To avoid potential danger, read and follow the following safety statements.
• S002
.
Chapter 4 Hardware replacement procedures
215