Memory Module Replacement; Remove A Memory Module - Lenovo ThinkSystem ST250 V2 Maintenance Manual

Step 2. Install an M.2 drive.
a. Insert the M.2 drive at an angle into the connector.
b. Pivot the M.2 drive down until the notch catches on the lip of the retainer.
c. Slide the retainer forward (towards the connector) to secure the M.2 drive into place.
Figure 78. Installing an M.2 drive
After this task is completed
• Complete the parts replacement. See "Complete the parts replacement" on page 217.
• Use the Lenovo XClarity Provisioning Manager to configure the RAID. For more information, see:
http://sysmgt.lenovofiles.com/help/topic/LXPM/RAID_setup.html

Memory module replacement

Follow instructions in this section to remove and install a memory module.

Remove a memory module

Follow instructions in this section to remove a memory module.
About this task
To avoid potential danger, read and follow the following safety statements.
• S002
CAUTION:
The power-control button on the device and the power switch on the power supply do not turn off
the electrical current supplied to the device. The device also might have more than one power cord.
To remove all electrical current from the device, ensure that all power cords are disconnected from
the power source.
Attention:
• Read the "Installation guidelines" on page 85 to ensure that you work safely.
ThinkSystem ST250 V2 Maintenance Manual
146