Lenovo ThinkSystem ST250 V2 Maintenance Manual page 115

• Depending on your server models, your server supports the following drive types:
– Up to sixteen 2.5-inch hot-swap SATA/SAS drives
– Up to eight 3.5-inch hot-swap SATA/SAS drives
– Up to four 3.5-inch hot-swap SATA/SAS drives and eight 2.5-inch hot-swap SATA/SAS drives
• For a complete list of supported drives and optional devices for the server, see:
us/en/serverproven/index.shtml
• The drive bays are numbered to indicate the installation order (starting from number "0"). Follow the
installation order when you install a drive. See "Front view" on page 17.
• The drives in a single RAID array must be the same type, same size, and same capacity.
Watch the procedure
A video of this procedure is available at YouTube:
DoEcxrm2zKNpaKOdZ3f8Qc
Procedure
Step 1. If a drive filler is installed in this drive bay, remove it first. Keep the drive filler in a safe place for
future use.
Step 2. Make sure that the drive tray handle is in the open position. Slide the drive into the drive bay until it
clicks in place.
Step 3. Rotate the drive handle to the fully closed position.
Figure 44. Installing the hot-swap drive
After this task is completed
1. If you have additional drives to install, do so now; if any of the drive bays is left empty, fill it with a drive
bay filler.
2. Complete the parts replacement. See "Complete the parts replacement" on page 217.
3. Check the drive activity LED to verify that the drive is operating correctly. See "Front panel" on page 19
for details.
https://youtube.com/playlist?list=PLYV5R7hVcs-
.
https://static.lenovo.com/
.
Chapter 4 Hardware replacement procedures
105