Table of Contents
Advertisement
Figure 56. Memory module installation
Step 4.
If you are installing additional memory modules, do so now.
After installing a memory module option:
1. Reinstall the system board air baffle (see
on page
106) or processor and memory expansion tray and expansion tray air baffle (see
processor and memory expansion tray" on page
2. Reinstall the top cover (see
3. Reconnect the power cords and any cables that you removed.
4. Install the server in the rack.
5. Power on the server and any peripheral devices.
6. If you have installed a DCPMM, make sure the DCPMM firmware is the latest version. If not, update it to
the latest version (see
7. Configure DCPMMs and DRAM DIMMs (see "Configuring Intel Optane DC Persistent Memory
(DCPMM)" in Setup Guide
Demo video
Watch the procedure on YouTube
Install a drive backplane
Use this procedure to install a drive backplane.
To install a drive backplane, complete the following steps:
Step 1.
Determine the location of the backplane to be installed accordingly to the following combinations.
For more details about drive bay numbering, see
• One drive backplane:
Always install the drive backplane to the drive bay 0-7 when there is only one backplane.
• Two drive backplanes:
Two types of drive backplanes are supported by this system:
– 2.5-inch SATA/SAS 8-bay backplane (referred to as "8-bay backplane")
– 2.5-inch AnyBay 8-bay backplane (referred to as "AnyBay backplane")
ThinkSystem SR850 Setup Guide
96
"Install the system board air baffle and the power interposer"
"Install the top cover" on page
https://sysmgt.lenovofiles.com/help/topic/com.lenovo.lxca.doc/update_fw.html
"Configure Persistent Memory Module (PMem)" on page
107).
110).
"Front view" on page
"Install the
).
121).
13.
Advertisement
Table of Contents
