Install The Hot-Swap Power Supply - Lenovo ThinkSystem ST250 V2 Maintenance Manual

Figure 103. Removing a hot-swap power supply
After this task is completed
1. Install a new power supply or install the power-supply filler to cover the power supply bay. See "Install
the hot-swap power supply" on page 179.
2. If you are instructed to return the component or optional device, follow all packaging instructions, and
use any packaging materials for shipping that are supplied to you.

Install the hot-swap power supply

Follow instructions in this section to install the hot-swap redundant power supply.
About this task
To avoid potential danger, read and follow the following safety statements.
• S001
.
Chapter 4 Hardware replacement procedures
179