Front Panel - Lenovo ThinkSystem ST250 V2 Maintenance Manual

N/A
3
Three SATA drives
4
(Bay 4, 5, 6) and
one SATA/NVMe
drive (Bay 7)
Four SATA drives
5
(Bay 0 to 3)
Note: When ThinkSystem 4350/5350/9350 series RAID adapters are installed, drive number starts from 1
instead of from 0.

Front panel

The front panel of the server provides controls, connectors, and LEDs.
The following illustration shows the control, connectors, and LEDs on the front panel of the server.
Figure 8. Front panel
Table 4. Components on the front panel
Callout
Power button with power status LED (green)
1
Drive activity LED (green)
2
Note: For onboard SATA indication only
Network activity LED (green)
3
Note: For onboard LAN indication only
System ID button with system ID LED (blue)
4
1 Power button with power status LED
You can press the power button to turn on the server when you finish setting up the server. You also can hold
the power button for several seconds to turn off the server if you cannot turn off the server from the operating
system. The power status LED helps you determine the current power status.
Status Color
Solid on Green
Slow blinking Green
(about one flash
per second)
Optical-drive bay Optical-drive bay
1: Optical/tape 1: Optical/tape
drive drive
Two SATA drives Four SAS/SATA
(Bay 4, 5) drives (Bay 4 to 7)
Four SATA drives Four SAS/SATA
(Bay 0 to 3) drives (Bay 0 to 3)
Description
The server is on and running.
The server is off and is ready to be powered on (standby state).
Optical-drive bay
1: Optical/tape
drive
Eight SAS/SATA
drives (Bay 8 to 15)
Eight SAS/SATA
drives (Bay 0 to 7)
Callout
System error LED (yellow)
5
XClarity Controller USB 2.0 connector
6
USB 3.2 Gen 1 connector
7
Chapter 2
Optical-drive bay
1: Optical/tape
drive
Eight SAS/SATA
drives (Bay 4 to 11)
Four SAS/SATA
drives (Bay 0 to 3)
.
Server components
19