Install A Tape Drive - Lenovo ThinkSystem ST250 V2 Setup Manual

Step 6. Save the removed EMI-protective shield from the chassis and the plastic bay filler from the front
bezel for future use.

Install a tape drive

Use this information to install a tape drive.
About this task
To avoid potential danger, read and follow the following safety statements.
• S002
CAUTION:
The power-control button on the device and the power switch on the power supply do not turn off
the electrical current supplied to the device. The device also might have more than one power cord.
To remove all electrical current from the device, ensure that all power cords are disconnected from
the power source.
• S006
CAUTION:
When laser products (such as CD-ROMs, DVD drives, fiber optic devices, or transmitters) are
installed, note the following:
– Do not remove the covers. Removing the covers of the laser product could result in exposure to
hazardous laser radiation. There are no serviceable parts inside the device.
– Use of controls or adjustments or performance of procedures other than those specified herein
might result in hazardous radiation exposure.
Attention:
• Read the "Installation guidelines" on page 61
• Touch the static-protective package that contains the component to any unpainted metal surface on the
server; then, remove it from the package and place it on a static-protective surface.
Watch the procedure
A video of this procedure is available at YouTube:
DoEcxrm2zKNpaKOdZ3f8Qc
To install a tape drive, complete the following steps:
Procedure
Step 1. The tape drive must be installed into the lower optical drive bay. If a filler is installed in the drive
bay, remove it first. Keep the drive filler in a safe place for future use.
ThinkSystem ST250 V2 Setup Guide
96
to ensure that you work safely.
https://youtube.com/playlist?list=PLYV5R7hVcs-
.