M.2 Boot Adapter Replacement; Remove The M.2 Boot Adapter - Lenovo ThinkSystem ST250 V2 Maintenance Manual

Step 1. Push the intrusion switch in the slot until it clicks into place.
Figure 67. Installing the intrusion switch
Step 2. Connect the cable to the corresponding connector on the system board. See "System-board
components" on page 27 and "M.2 adapter, intrusion switch, and RAID flash power module" on
page 66.
After this task is completed
Complete the parts replacement. See "Complete the parts replacement" on page 217.

M.2 boot adapter replacement

Follow instructions in this section to remove and install the M.2 boot adapter.

Remove the M.2 boot adapter

Follow instructions in this section to remove the M.2 boot adapter.
About this task
To avoid potential danger, read and follow the following safety statements.
• S002
CAUTION:
The power-control button on the device and the power switch on the power supply do not turn off
the electrical current supplied to the device. The device also might have more than one power cord.
To remove all electrical current from the device, ensure that all power cords are disconnected from
the power source.
Attention:
• Read the "Installation guidelines" on page 85 to ensure that you work safely.
.
Chapter 4 Hardware replacement procedures
137