Adding A Bootp Entry - Nortel BayStack 650 User Manual

Adding a BOOTP Entry

The BOOTP table is only for the access points; that is, it will not give a BOOTP
address to another computer. Also, DHCP addressing takes precedence over other
addressing methods. This means that the access point will try DHCP first, before
it tries BOOTP.
After you assign a static IP address, the only way to use DHCP/BOOTP is to reset
the access point to its factory defaults.
To add a BOOTP entry:
Choose Tools > BOOTP Table.
1.
The BOOTP dialog box
Figure 5-9.
203282-B
(Figure 5-9) opens.
BOOTP Dialog Box
Managing the Access Point
5-11