Using Help To Set The Ip Address - Nortel BayStack 650 User Manual

Using the BayStack 650 Wireless LAN Access Point
To set the IP address using the BOOTP Request dialog box:
Enter the following information:
1.
•
•
•
Note: If you do not know the address for the three fields, contact your system
administrator. It is important that you enter the information correctly.
Choose whether the settings will Permanent or Dynamic.
2.
•
•
Note: If you select Permanent and the BOOTP Request dialog box
opens again, change the setting to Dynamic.
Click OK.
3.

Using Help to Set the IP Address

You can also use Help set the IP address. To set the IP Address using Help:
In the BOOTP Request dialog box
1.
The IP Configuration Help dialog box opens.
In the IP Address entry field, enter the last digits of the IP address.
2.
Choose Permanent or Dynamic.
3.
Note: If you select Permanent and your system again requests an IP address
after you reboot, choose Dynamic (and vice versa).
Click OK.
4.
4-4
IP Address
Subnet Mask
Gateway
If you click Permanent, the access point assigns the configuration
permanently in flash memory and retains the configuration even if
rebooted.
If you click Dynamic, the values added are entered in the BOOTP table.
(Figure 4-2), click Help.
(Figure 4-2)
203282-B