Nortel BayStack 650 User Manual page 114

Using the BayStack 650 Wireless LAN Access Point
Table 6-1.
Fail-over commands—Use these commands to configure/display
fail-over attributes.
fov ether-link-detect {enable | disable}
fov infrstr-ping {enable | disable}
fov ping-target-addr <ip_addr>
fov show
Help commands—Use these commands to display command groups
and command syntax.
help
help <commmod_group>
IAPP commands—Use these commands to configure/display
Inter-Access Point Protocol (IAPP) attributes.
iapp interval <num_sec>
iapp multi-vendor {enable | disable}
iapp show
Logging commands—Use these commands to clear and to display
error log.
log clear
log show
Logout command—Use this command to log out from Access Point.
logout
MAC commands—Use these commands to configure/display wireless
MAC layer attributes.
mac beacon-interval <num_tu>
mac dtim-period <num_beacon_intervals>
mac frag-threshold <num_octets>
mac rts-threshold <num_bytes>
mac show
password command—Use this command to change password
password <password>
reboot command—Use this command to reboot an Access Point.
reboot
6-4
CLI Command List (continued)
Go to page 6-12
Go to page 6-11
Go to page 6-14
Go to page 6-15
Go to page 6-16
203282-B