Nortel BayStack 650 User Manual page 115

Table 6-1.
SNMP commands—Use these commands to configure/display SNMP
attributes.
snmp show {community | hosts | security}
PHY command—Use these commands to configure/display wireless
PHY layer attributes.
phy add-bss-basic-rate <num_Mbps>
phy channel <channel_no>
phy delete-bss-basic-rate <num_Mbps>
phy dwell-time <num_kus>
phy hop-sequence <pattern_no>
phy show
System commands—Use these commands to configure/display system
attributes.
sys essid <ess_id_name>
sys ether-link-mode {10base_2 | 10base_t}
sys gateway <gtw_ip_addr>
sys ip-address <sys_ip_addr> <sys_net_mask>
sys ip-on-wport {enable | disable}
sys load-image <file_name> <tftpd_ip_addr>
sys name <sys_name>
sys show
WEP commands—Use these commands to configure/display Wired
Equivalent Privacy (WEP) attributes.
wep default-key <key_id>
wep exclude-unencrypt {on | off}
wep show
203282-B
CLI Command List (continued)
Command Line Interface
Go to page 6-19
Go to page 6-17
Go to page 6-20
Go to page 6-22
6-5