Nortel BayStack 650 User Manual page 101

Click the action that you want to perform
3.
Table 5-2.
Action
Reboot
Turn Adapter Power Off
Turn Adapter Power On
Commit Configuration To
Flash
Commit IP Configuration
To Flash
Set to Factory Defaults
Upgrade Access Point
Firmware
Upgrade Adapter
Firmware
Click OK.
4.
The AP Manager logs in to each access points and then applies the changes.
Click Yes to confirm the action.
5.
The BayStack AP Manager main window is displayed.
203282-B
Function of the Actions Menu
Description
Reboots all access points.
Turns off the power to all adapters (PC card) inserted in all
access points.
Turns on the power to all adapters (PC card) inserted in all
access points.
This option commits all settings to flash, including IP address,
subnet mask, WEP settings, etc. to flash.
This option commits only IP address, subnet mask, and
Gateway addresses settings to flash.
Resets all access points back to their factory default settings.
Use this option to flash upgrade the firmware for all access
points. Obtain the new firmware from Nortel Networks
technical support. Go to
Troubleshooting" for information on obtaining a flash upgrade.
Use this option to flash upgrade the firmware for all adapters
inserted in all access points. Obtain the new firmware from
Nortel Networks technical support. Go to
"Diagnostics and
obtaining a flash upgrade.
Managing the Access Point
(Table 5-2).
Chapter 7, "Diagnostics and
Troubleshooting" for information on
Chapter 7,
5-7