Nortel BayStack 650 User Manual page 141

In the AP Manager, select Configure > Access Points and make sure your
3.
access point appears in the Access Points list (see
If not, confirm that both the access point and the workstation running the
4.
AP Manager are connected to the same Ethernet segment.
Power cycle your access point.
5.
Again, select Configure > Access Points and check whether your access
6.
point appears in the Access Points list (see
If not, connect your access point to a 10Mbps port on the same Ethernet
7.
segment as the workstation running the AP Manager. Power cycle your
access point (100BaseT networks only).
At a command prompt on the workstation, check whether you can ping
8.
the IP address assigned to the access point.
Check your Windows documentation for instructions.
If not, check the IP subnet mask that was assigned to your access point.
9.
Reconfigure the TCP/IP settings on the workstation running the AP
10.
Manager to match the subnet mask of your access point. Retry
management.
Check your Windows documentation for instructions on TCP/IP
configuration.
If necessary, connect your access point and the workstation running the
11.
AP Manager to a stand alone Ethernet hub (10BaseT) and retry.
If necessary, modify the TCP/IP settings of the laptop by trial and error
12.
to identify the correct IP subnet mask.
Check your Windows documentation for instructions on TCP/IP
configuration.
If problems persist, contact Nortel Networks customer support. For
13.
contact details see http://www.nortelnetwork.com/servsup.com. Go to the
"BayStack Workgroup Products" category, and then use the "ERC" link.
203282-B
Diagnostics and Troubleshooting
Figure 4-4 on
Figure 4-4 on page
page 4-7).
4-7).
7-7