3: Zone Setup - Honeywell NOTIFIER FireWarden-100-2 Instruction Manual

Programming
3.6.3 Zone Setup
PROGRAMMING
1=AUTOPROGRAM
2=POINT PROGRAM
3=ZONE SETUP
Programming Screen #2
ZONE SETUP
1=ENABLE
2=DISABLE
3=ZONE 97 98 99
Zone Setup Screen #1
72
Pressing 3 while viewing Programming Screen #2 will access the Zone Setup screens as illustrated
below:
1=ENABLE
2=DISABLE
3=ZONE 97 98 99
1=ZONES INSTALLED
2=ZONES ENABLED
3=ZONES DISABLED
1=ZONE TYPES
2=ZONES AVAILABLE
Enable
Pressing 1 for Enable, while viewing Zone Setup Screen #1, will display the following screen:
Z
This screens allows the programmer to enable zones, one at a time. A flashing cursor appears next
to the Z, prompting the programmer to enter a two digit zone number (01 - 99). When the second
digit is entered, the zone will be enabled and the cursor returns to the original position next to the Z.
Another zone can then be enabled.
ZONE SETUP
Zone Setup Screen #1
ZONE SETUP
Zone Setup Screen #2
ZONE SETUP
Zone Setup Screen #3
ZONE TO ENABLE
Enable Screen
FireWarden 100-2/E — P/N 52778:A 11/04/2005
Master Programming Level