Honeywell NOTIFIER FireWarden-100-2 Instruction Manual page 56

Programming
Pressing 1 for Control Module or 2 for Monitor Module will cause the following screen to be
displayed:
The programmer can continue adding modules by pressing the ESC or left arrow key which will
return the display to the Add Module Screen #1.
programmer to delete a specific module:
MODULES
1=ADD
2=DELETE
3=EDIT
Modules Screen
A flashing cursor will appear in the position of the first asterisk to the left. Using the panel keypad,
key in the module address such as 005. When the last digit is keyed in, the following confirmation
that the module has been deleted will be displayed:
The programmer can change a modules existing or factory default programming by pressing 3 in
the Modules Screen. The following screen will be displayed:
56
MODULE#
IS ADDED
Delete Module
Pressing 2 in the Modules Screen will display the Delete Module Screen which allows the
ENTER MODULE#
***
MODULE#
IS DELETED
Edit Module Screen for Monitor Module
ENTER MODULE ADDRESS
***
ADD MODULE
Add Module Screen #3
DELETE MODULE
Delete Module Screen
DELETE MODULE
EDIT MODULE
Edit Module Screen
FireWarden 100-2/E — P/N 52778:A 11/04/2005
Master Programming Level
005
005