Table of Contents
Advertisement
Master Programming Level
3.6.10 Password Change
The factory set passwords, which have been programmed into the control panel, can be changed by
PROGRAMMING
selecting the Password Change option. Pressing 1 while viewing Programming Screen #4 will
1=PASSWORD CHANGE
cause the following screen to be displayed:
2=CLEAR PROGRAM
3=PROGRAM CHECK
Programming Screen #4
Press 1 to change the Master Programming Level password or 2 to change the Maintenance Level
password. Note that the passwords will not be displayed on FDU-80 annunciators.
The following screen will appear when either change option is selected:
A flashing cursor will appear in the center of the display. Enter a new five digit password (such as
10101 for the Master Level). After the fifth digit is entered, the following screen will be displayed:
Pressing the Enter key will program the new password into the control panel and return the display
to the Password Change Screen.
3.6.11 Clear Program
Pressing 2 while viewing Programming Screen #4, will select the Clear Program option. This will
PROGRAMMING
cause the LCD to display the following screen:
1=PASSWORD CHANGE
2=CLEAR PROGRAM
3=PROGRAM CHECK
Programming Screen #4
FireWarden 100-2/E — P/N 52778:A 11/04/2005
PASSWORD CHANGE
1=MASTER
2=MAINTENANCE
Password Change Screen
ENTER NEW FIVE DIGIT
PASSWORD
Enter Password Screen
NEW MASTER
PASSWORD IS
PRESS ENTER IF OK
Password Change Screen
CLEAR PROGRAM
1=WHOLE SYSTEM
2=ALL POINTS
Clear Program Screen #1
10101
Programming
113
Advertisement
Table of Contents
