Table of Contents
Advertisement
Programming
3.6.1 Autoprogram
Pressing 1 while viewing Programming Screen #1, will select the Autoprogram option, which
PROGRAMMING
prompts the control panel to poll all devices installed on the SLC loop. The primary purpose of
1=AUTOPROGRAM
autoprogramming is to allow the installer a fast and easy way to bring the system on-line as quickly
2=POINT PROGRAM
as possible. The first time the system is powered-up, it should be autoprogrammed.
3=ZONE SETUP
Programming Screen #1
If the system is already programmed and Autoprogram is initiated, the system will only add default
values for newly installed devices.
When Autoprogram is selected, the control panel will begin autoprogramming the system by
communicating with each addressable device installed on the SLC loop. While autoprogramming,
the panel will display the following:
When Autoprogramming is completed, the control panel will display the type and quantity of each
device installed on the SLC loop similar to the following display:
In the preceding example, the display indicates that the SLC Loop has 55 addressable detectors, 35
monitor modules and 30 control modules installed.
Pressing the ESC key will return the display to Programming Screen #1.
3.6.2 Point Program
The Point Program option allows the programmer to add a new addressable device to an SLC loop,
PROGRAMMING
delete an existing device from a loop or change the programming for an existing device. Pressing
1=AUTOPROGRAM
2, while viewing Programming Screen #1, will select the Point Program option and display the
2=POINT PROGRAM
following screen:
3=ZONE SETUP
Programming Screen #1
44
AUTOPROGRAM
AUTOPROGRAMMING!
PLEASE WAIT
Autoprogram Progress Screen
# OF DET LOOP1 055
# OF MON LOOP1 035
# OF CON LOOP1 030
Autoprogram Result Screen #1
POINT PROGRAM
SELECT TYPE
1=DETECTOR
2=MODULE
Point Program Screen
Master Programming Level
FireWarden 100-2/E — P/N 52778:A 11/04/2005
Advertisement
Table of Contents
