Programming Instructions For System Event Reporting - Interlogix xGenConnect NXG-4 Installation And Programming Manual

Example
Menu 3 – Zones
Zone 3 in Alarm
Area Group = 1
Zone sends alarm to
Area group
Menu 12 – Area Groups
Area Group 1
Area 1
Area 2
Event sent to lowest Area
Menu 4 – Areas
Area 1
Channel Group 1
Area sends event to
Channel Group
Menu 18 – Channel Groups
Channel Group 1
Channel 1
Channel 4
Channel Group sends Event
Channel 6
to
Next
•
Program Users.
•
Program advanced Schedules and Alternate Zone Profiles.

Programming Instructions for System Event Reporting

Pre-conditions
Communicator must be programmed (see "Programming Instructions for
Communicator" on page 130).
Event Lists must be programmed (see "Programming Instructions for Event Lists"
on page 135).
Channels and Channel Groups must be programmed (see "Programming
Instructions for Channels" on page 137).
Notes
•
The system event will only be reported by a channel, if that Channel includes
that event in the associated Event List(s).
xGenConnect Installation and Programming Guide
Menu 5 – Channels
Channel checks to see if
the event is on its Event List,
if yes it will attempt to send,
if not then it stops
every Channel it contains
Channel 1
Control Room 1
Event List = 1
Channel Attempts = 3
Next Channel = 2
Channel 4
Control Room 2
Event List = 1
Next Channel = 5
Channel 6
Email
Event List = 2
Next Channel = 0
Channel 2
Control Room 1
Event List = 1
Channel Attempts = 3
Next Channel = 0
If it does not succeed after
Channel Attempts, it will try
sending on the next Channel
Channel 5
Control Room 2
Event List = 1
Next Channel = 0
143