Table of Contents
Advertisement
NXG-4 Wiring Diagram
ANT 2
ANT 1
RF
LEARN
ULTRASYNC
LAN
TERM
-BLACK
+ RED
12V 4AH
BUS
BATTERY
J11
J14
USBUP TAMPER
LINK
NXG-4 Terminals
Refer to "NXG-8(E) Terminals" on page 19.
The NXG-4 unit functionality is the same as NXG-8 except it provides two
additional connections:
•
Antenna 1: After the board is installed in the metal enclosure, insert the
antenna with the corresponding icon.
•
Antenna 2: After the board is installed in the metal enclosure, insert the
antenna with the corresponding icon.
NXG-4 LEDs
Refer to "NXG-8(E) LEDs" on page 20.
The NXG-4 unit functionality is the same as NXG-8 except it has the following
additional LED:
•
D5 RF: Red LED blinks when message is sent or received from a 63bit /
80plus transmitter.
22
Refer to "NXG-8(E) Wiring Diagram" on
page 17. The NXG-4 unit functionality is the
LAN-
same as NXG-8 except that the connections
LAN+
are spatially orientated differently.
NEG
POS
AC
AC
EARTH
OUTPUT 3-
AUX+
BELL-
OUTPUT 2-
OUTPUT 1-
DATA
COM
POS
ZONE 4
COM
ZONE 3
ZONE 2
COM
ZONE 1
xGenConnect Installation and Programming Guide
Hide quick links:
Advertisement
Table of Contents
