Table of Contents
Advertisement
NXG-001 Plastic Enclosure
The NXG-001 features a DIN rail for mounting xGen modules, a tamper switch,
and integrated cable management.
The enclosure should be installed in accordance with EN 50131-1 Environmental
Class II to provide operating conditions within:
•
Temperature range: −10 to +55°C.
•
Humidity range: Average 93% relative humidity, noncondensing
The lid can be removed by releasing the two screws using the supplied Allen key.
Note:
The housing cover must be installed with the clips on top.
Refer to drilling template provided with enclosure for mounting instructions.
To install a module, release the locking tab(s) and place on the DIN rail then
push the locking tab(s) to secure the module. To remove a module, use a small
flat-blade screwdriver to release the locking tab(s) on the xGen module then
remove from the DIN rail. Refer to module installation manual for further details.
28
xGenConnect Installation and Programming Guide
Hide quick links:
Advertisement
Table of Contents
