Interlogix xGenConnect NXG-4 Installation And Programming Manual page 173

Creating a customized company logo requires the following:
•
Computer or laptop with application to edit and create .bmp files (for example,
Microsoft Paint)
•
DLX900 v5.15 or higher to create .MIF3 file out of the .bmp file
•
USBUP-EUR-V2 (or DLX900) to flash the NXG-183x keypad with the
company logo file (.MIF3)
The company logo file can be created by using a computer and a simple
application like MS Paint. In order to create a company logo file and upload this
file onto the keypad, follow these steps:
1. Create an image using any application capable of editing and saving .bmp
files. In example, use Microsoft Paint on a Windows computer or laptop.
The image must be monochrome (black and white), no colors or shades of
gray are supported. The image size should not exceed 256 x 48 pixels (full
screen size of NXG-183x).
As an example, the picture below shows the file properties in MS Paint, with
the relevant options properly set:
2. Save the prepared image as a black-and-white file type with .bmp extension.
For MS Paint, select file type Monochrome Bitmap (*.bmp, *.dib).
3. Open DLX900 software (version 5.15 or higher), connect to the system or just
open the DLX900 account for which there is the NXG-183x-EUR keypad and
for which you want to upload the new company logo file.
4. Go to Devices / Device Info / Keypad. Select the NXG-183x keypad.
5. Click Create file button in USBUp section. Next, select Logo Bmp file option in
the component selection window (see figure below). Press OK.
xGenConnect Installation and Programming Guide 161